**********************************************************************  

	Readme File for WindoWasher Version 1.0 Release 8/94
		Copyright 1994  Micah Development Corp.


Default Access Ranges
---------------------
WindoWasher's default values for the Access Ranges are 0, 1, 2, 
and 3.  As file activity increases, you may want to alter these 
ranges to a higher setting.  To alter the ranges, select Define 
Ranges... under the Options menu from within WindoWasher.  


Third Party Display Drivers
---------------------------
The FileFlash and NetFlash utilities may not work properly with 
third party display drivers.  If file accesses are not displayed
in the upper right hand corner of the screen after WindoWasher is 
installed and the PC is rebooted, run the Windows Setup program 
to change the display setting to a configuration that is compatible.  
See Appendix A, "Compatibility Issues," for more information.


WFW 32-Bit File Access
----------------------
This version of WindoWasher is not compatible with the 32-bit file
access setting included with Windows for Workgroups 3.11.


Defrag Utilities
----------------
Some defrag utilities may hang while WindoWasher is active.  If this
occurs and you need to defragment your hard drive, you must reset the
counters and temporarily remove WindoWasher from the CONFIG.SYS file.
See Appendix A, "Compatibility Issues," for appropriate procedures
to ensuring compatibility with disk utilities.


**********************************************************************